🆕 𝐏𝐈𝐓𝐀𝐘𝐀 𝐛𝐨𝐚𝐫𝐝 𝐕𝟎𝟔 𝐢𝐬 𝐛𝐨𝐫𝐧!
Yesterday, I wrote about the DAC11001 board in its 6th revision.
In version 05, I moved mounting hole positions on this board. I didn’t have a chance to synchronise both designs until this revision run.
Did I prepare 3D models during the design? Yes.
Did I check them? Yes.
Where on Earth did the mistake happen? Well. I moved the RedPitaya STEM board a little and was so eager to finish the layout that I didn’t make the final 3D model checks.
𝑊ℎ𝑎𝑡 𝑖𝑠 𝑎 𝑐𝑜𝑟𝑟𝑒𝑐𝑡𝑖𝑣𝑒 𝑎𝑐𝑡𝑖𝑜𝑛? 𝐼 𝑎𝑑𝑑𝑒𝑑 𝑎𝑛𝑜𝑡ℎ𝑒𝑟 𝑝𝑜𝑖𝑛𝑡 𝑡𝑜 𝑡ℎ𝑒 𝐻𝑊 𝑑𝑒𝑠𝑖𝑔𝑛 𝑐ℎ𝑒𝑐𝑘𝑙𝑖𝑠𝑡.
PITAYA06
